What Are Juniper Routers? Network Equipment at Centre of Nationwide FAA Ground Stop

US witnessed a nationwide ground stop on Friday.

\n\n

The Federal Aviation Administration (FAA) has paused the installation of new Juniper telecommunications routers as it investigates the communications failure that led to last week’s nationwide ground stop, which halted flights across the US and caused travel disruption over the weekend.

\n\n

The move, confirmed by an agency spokesperson to CNN, was first reported by The Wall Street Journal. Investigators are trying to establish whether the disruption was caused by defective equipment or an installation or configuration error.

\n\n

Friday’s ground stop lasted about four hours, but its effects continued through the weekend, disrupting thousands of flights. It was the second nationwide halt to all departures since the September 11, 2001 attacks.

\n\n

According to The Wall Street Journal, FAA employees investigating the incident found that network equipment at a radio site in El Dorado, Arkansas, and possibly a radar site in Amarillo, Texas, had overloaded the communications system used by air traffic controllers.

\n\n

The FAA has not yet determined whether the router in Arkansas was faulty or whether it was incorrectly configured. The agency is pausing further installations while it assesses what went wrong.

\n\n

For now, the FAA is relying on older Cisco routers…

Original source: https://www.timesnownews.com/latest-news

Leave a Reply

Your email address will not be published. Required fields are marked *